Page 1 of 1

Peach doesn't recognize the name of the function

PostPosted: 2013-05-23 07:22:03
by garrett
At the moment I'm using Techila for my project. I'm writing to you, because I faced the problems with using control parameter
:cf mfilename='file.m' of the cloudfor.

Compilation of the file for workers take a time, that is why I'd like to use pre-compiled file.

The peach function doesn't recognize the name of the function I give, and takes the default name techila_for.m.

I don't understand what I'm doing wrong?

Re: Peach doesn't recognize the name of the function

PostPosted: 2013-05-24 07:39:52
by eerola
Are you using cloudfor or peach? Typically it is only required to use only one helper function, not both at the same time. In the Techila SDK there are examples under the 'techila\examples\Matlab' directory, which illustrate how to use these functions. When using either cloudfor or peach, compiling is typicallyx required only if you change the code. If the code remains unchanged, recompiling is not needed.

The 'mfilename' parameter is only used to change the file name of the techila_for.m and is probably not doing what you would like to achieve.